CD450-4J SINGLE CIRCUIT MACHINE

$495.00
Item
33988
CD450-4J SINGLE CIRCUIT MACHINE

CLICK HERE TO DOWNLOAD SPEC SHEET

 

Model: CD450-4J & CD450-JOD

Volts Output: 450

Energy Output: 4 Joules

Capacity: 142 Ohms (65 Electric Blasting Caps)

Capacity Parallel Series: Not recommended.

Weight: 0.8 lbs.

Size: 4.1” x 2.2” x 3.6”

Power Source: One 9 Volt Battery

 

FEATURES

Solid-state circuitry assures excellent reliability and service life.
Safety Interlock.
Sturdy construction for extended service life.
Rugged water and environmentally sealed to operate in most weather.
Heavy-duty, long life, ALKALINE batteries provide efficient and dependable power.
Fast battery change, using temperature compensated circuits facilitate cold weather operation.
 

OPERATION

Use of this equipment requires training in blasting techniques. Contact your powder company representative for training information.
This equipment must be operated in accordance with US Federal health and safety standards, state laws, rules and other applicable statutory provisions.
 

SUITABILITY:

Properly trained and skilled personnel must determine suitability and safety factors of each blast.
 

IMPORTANT:

Devices such as the REO Blasting Machine Energy Testers must be used to determine the energy output of each circuit prior to each blast.
Lead lines shall not be connected to the blasting machine until the circuit wiring has been verified by approved testers, the blast is ready to be fired and area safety is assured.
After the lead lines have been connected to the blasting machine, depress the CHARGE switch and hold it down. When the READY TO FIRE indicator lights, depress the FIRE switch while continuing to depress the CHARGE switch. Unless the CHARGE and FIRE switches are operated together, the machine will not fire.
 

CAUTION:

WITH THIS MACHINE, AS WITH ALL BLASTING EQUIPMENT, STANDARD SAFETY RULES SHOULD BE FOLLOWED WHICH INCLUDE THESE: KEEP THE BLAST AREA CLEAR OF UNAUTHORIZED PERSONNEL, KEEP BODY AND HANDS AWAY FROM CONDUCTORS AND USE ONLY APPROVED TEST EQUIPMENT.
 

BATTERY LIFE:

A lighted READY TO FIRE indicator confirms that the battery power was sufficient to charge the capacitors to the design voltage and the safety circuit is released.
The amount of time it takes for the READY TO FIRE indicator light to illuminate reflects remaining battery life. After months of firing cycles, a longer charge time will be required. However, regardless of battery condition, the full design voltage is present and the unit's safety circuits are released if the READY TO FIRE indicator is illuminated.
CD450-4J: Up to 350 charges
 

SAFETY FEATURES:

The blasting machine cannot be fired until the design voltage is verified, and the safety circuit is released.
The case is sealed against moisture and dust and is shock resistant.
Capacitors are shunted until the "Charge" switch is depressed.
The two terminals are shunted until the "Fire" switch is depressed.

© 2024 Blasters Tool & Supply Co., Inc, All Rights Reserved.