HB-50 BTS Blasting Machine

HB50
Scorpion SolidState Electronic Blasting Machine 
Operation:To Test: Always check blasting circuit with appropriate for blasting test device prior to connecting to Blasting Machine. Before connecting to blastingcircuit, depress CHARGE switch until READY light illuminates. While maintaining pressure on CHARGE switch depress DETONATE switch.

READY light should extinguish immediately.
Caution: Do NOT relax CHARGE switch when depressing DETONATE switch. The dual switch firing circuit assures the blasters intent to

initiate.

When READY light fails to illuminate within 8 seconds , replace the Heavy Duty Alkaline 9V battery accessible through the battery cap located on the right side of the unit. Make note to insure proper polarity when replacing battery. Connect Blasting Machine to blasting circuit and repeat CHARGE AND DETONATE sequence as in To Test. NEVER use the HB50 as an alternate energy source on equipment for which it was not designed. Never use a damaged or questionable machine
Mechanical:
Case Material:
   H.D. Urethane
Case Size:
   3"W x 1.5"D x 4"H
 
   7.6cm W x 3.81cm D x 10.13cm H
Weight:
   15.8 oz. (0.312 kg)
Shipping Weight:
   2 lb. (0.908 kg)
Electrical:

Type of Circuitry:
   Solid State Electronic
Firing Control Circuit:
   SCR (silicon controlled rectifier)
Firing Voltage:
   220 VDC Minimum / 225 VDC Maximum
Firing Energy:
   4.0 Joule (w/s)
Power Source:
   1 Ea. 9V Alkaline Cell (NEDA  )
Battery Voltage:
   9V
H.V. Source:
   Inverter, Solid State Electronic
Energy Storage:
   Capacitor, Special Electrolytic, H.D.
Capacity:

Straight Series:
   50 - 2 Ohm Electric Blasting Caps
Series Parallel:
   2 Series of 25 - 2 Ohm Electric Blasting Caps
Max. Ohms @ 1.5 Amperes & 0.025 Joules / Ohm Circ. Res.:
   135

MANUFACTURER LIMITED LIFETIME WARRANTY