ET4J-1 ENERGY TESTER

$105.00
Item
33999
ET4J-1 ENERGY TESTER

CLICK HERE TO DOWNLOAD SPEC SHEET

Model No.: ET4J-1 Energy Tester
Use: CD450-4J Machine ONLY
Accuracy: +/- 5%
Weight: 1.3 oz
Size: 1.7 x 2.2 x 0.7 inches


FEATURES:
- Provides a field check of energy output of the blasting machine.
- Easy to operate.
- Contains no batteries.
- Rugged water and corrosion resistant nylon plastic case.
- Environmentally sealed to operate in most weather.
- Tab terminals connect directly to the blasting machine.
- Low cost.
- May be placed on a key ring or slips easily into shirt or jacket pocket


OPERATION:
Connect the two-tab terminals on the tester to the terminals on the blasting machine by placing
the tab under the shoulder of the blasting machine terminal and tightening securely. Observe
the polarity indicated on the tester (RD tab to RED terminal and BK tab to BLACK terminal).
Fire the blasting machine and watch the ENERGY OK light on the tester. The ENERGY OK
light will flash briefly if the output energy of the blasting machine is 100% or greater. No flash
indicates that the blasting machine energy output may be low, and the blasting machine should
be removed from service and tested in a laboratory using established procedures utilizing an
oscilloscope and a load resistor

© 2024 Blasters Tool & Supply Co., Inc, All Rights Reserved.